LASERLINE EPS4012F 4 WAY FRONT PARKING SENSORS

New flush mount behind bumper fitment for that factory OEM look

Laserline's new EPS4012F kit has been designed to give you that new factory look to your parking sensors

Fitted from behind the bumper into special mounts, the sensors 'poke' through the hole cut in the bumper for a factory look and feel.

Each sensor is just 18mm across

Can be connected to the vehicle speed pulse via an analogue speed pulse, an additional Can Bus adaptor may be required on certain vehicles

Optional switch is available if you wish to turn the sensors on and off manually

It is often impossible to judge how much room is available when reversing into a parking space, especially in vehicles with restricted rear vision.

Laserline's EPS system automatically creates an invisible detection zone immediately reverse gear is selected.

As the vehicle is reversed towards an obstacle an audible warning is emited which increases in frequency until the tone becomes continuous at 30cm.

An increasing number of new vehicles are being fitted with reverse parking aids. Now, car owners can purchase a quality product which will protect their investment at relatively low cost.

Package includes

Controller box

Installation instructions

Buzzer

4 x Front flush mount sensors

4 x Front mount collars (for standard installation if necessary)

Cables and mounting accessories

Please note that the price shown is for SUPPLY only - NOT fitting