Features:

Clamp for 3145-20 Noise Sensor

• Clamp the clamp on noise sensor around the lan cable and monitor the noise Hilogger display
• Measurement with the clamp on noise sensor is earth-free
• The clamp on noise sensor measures noise current
• The noise current level and frequency of the earth line can be measured simply, without direct contact
• Measures by 7" width by 2-5/7" height by 1" depth

Clamp the clamp on noise sensor around the lan cable and monitor the noise Hilogger display. Measurement with the clamp on noise sensor is earth-free. The clamp on noise sensor measures noise current. The noise current level and frequency of the earth line can be measured simply, without direct contact. Because measurement requires no electrical contact, there's no need to worry about interfering with communications, electric shock or short circuits, and use is simple and safe even in active-line conditions. 1kHz to 100MHz (-3dB) band width. AC 10A (15A peak) rated current. +/-3.0 percent rdg, +/- 0.001 percent fs (fs = 10A, f=15kHz, with conductor centered in clamp) amplitude accuracy. up to f20mm measurable conductor diameter. CAT II 600V, CAT III 300V (insulated conductor) maximum rated voltage to earth. Measures 6-59/64" width by 2-23/32" height by 1-19/32" depth. 2m Cord length.