Overview: 

PM03D provides regulated power supply as well as current consumption and battery voltage measurements via I2C digital protocol all through a 6pin 2.00mm CLIK-Mate cable. Compatible to flight controller that uses I2C power monitor such as the Pixhawk 5X and up. 

It is design for multi-rotor like the X500 V2. It has both XT-30 & XT-60 connectors preinstalled for motor ESCs and Battery, as well as two 5V BEC and a selectable 8V/12V output different kinds of peripheral devices. 

Please Note:

• • Full setup guide can be found  here.
• • This PM uses I2C digital signal data output, Compatible with Pixhawk 5X/6X Series.
  • NOT compatible with flight controller that uses analog PM such as the Pixhawk 6C & Mini, Pixhawk4 & Mini, pix32 v5, or Durandal flight controllers.
• • Power Module Comparison Table

Features:

• • Plug & play, no additional setup required for QGroundcontrol & Mission Planner
• • XT-30 connectors and solder pads for easy motor ESC connection
• • Onboard voltage regulators: two 5.2V & one selectable 8V/12V
• • 5V/A ports for powering companion computer or peripheral device
• • Selectable 8V or 12V triple row pin header for powering peripheral device

Specifications:

• • Maximum input voltage: 6S battery
• • Rated current: 60A
• • Max current: 120A (<60 Sec)
• • Max current sensing: 164A
• • Connections
• XT-60 for battery
• XT-30 for motor & peripheral device (battery voltage)
• Solder pads in each corner (battery voltage)
• CLIK-Mate 2.0mm for flight controller (5.2V/3A standalone BEC)
• JST GH 4pin (5.2V/3A, BEC shared with 5.2V triple row pin header)
• 2x Triple row pin header (5.2V/3A, BEC shared with JST GH 4pin)
• 2x Triple row pin header (8V or 12V selectable by moving header jumper, 3A)
• • Output: DC 5.2V & 3A Max
• • Voltage and current monitor with I2C compatible interface
  
• • Weight: 20g

The XT60 plug and 12AWG wire that PM03D comes with is rated for 30A continuous current and 60A instantaneous current (<1 minute). If a higher current is being used, the plug type and wire size should be changed accordingly.

Package Includes：

• - 1x PM06 board
• - 1x 80mm XT60 connector wire (pre-soldered)
• - Electrolytic capacitor: 220uF 63V (pre-soldered)
• - 1x 2.0mm pitch CLIK-Mate 6pin cable (To power flight controller)
• - 4pin JST GH to USB Type C
• - 4pin JST GH to barrel plug (2.1*5.5mm)
• - 4pin JST GH to barrel plug (2.5*5.5mm)
• - 4pin Pin Dupont Cable (2pc)
• - Nylon standoffs & nuts