Available in a 10 oz. tube, Pyrolite E-Z FILL Adhesive is a high-temperature joint and repair product for use where direct molten metal contact is not required.

Surfaces to be bonded must be clean and free of loose particles, dust and release coating. Curing takes place through normal air drying. Low temperature heat (up to 200°F or 95°C) can be used to accelerate the process, if necessary. This can be accomplished using a hot air blower or low velocity flame.

The product should be stored between 40°F (4°C) and 90°F (32°C). Under these conditions, the normal shelf life is one year. In temperature and humidity controlled storage, a shelf life of two + years may be expected. It can be used in environments up to 2300°F or 1260°C.

Directions:
Smear on the product, use a squeegee or credit card to smooth it onto the surface, allow to become bone dry, and then lightly sand to the desired smoothness using finer and finer grits of sand paper. This product is an allowable substrate for kiln wash, so the kiln wash will not pool where the Pyrolite is applied.