Holley set the bar in 2011 with the release of the HP andDominator in-line fuel pumps. In 2015, Holley has raised thebar again with the introduction of the VR1 and VR2 Brushless in-line fuel pumps. Featuring brushless pump technology and a twin screw rotor design, the VR1 and VR2 in-line fuel pumps arecapable of high pressures and flows while maintaining a low amperage draw and quiet performance. Designed to work on high boosted race cars as well as your daily driven weekend endurance car, these pumps work with gasoline, methanol, and E-85* (Compatible for methanol and E85 for competitive drag race use only- when draining and flushing after each race event) and can maintain pressures of 130 PSI and up to335 GPH flow**. Fueled by TI Automotive.

1. The pumps include a 2 step controller for pump speed control.
2. The pumps canbe ran in one of two differentspeeds. A low speed
3. control for low fuel consumption requirements or at full speed
4. for high fuel consumption requirements. The VR2 includes(2) controllers for precise control of both pumps independently of each other. Both the VR1 and VR2 pumps areproven for 18.5V compatibility.
5. **At 13.8V

Features:

• Capable of 130 PSI while providing significant flow forforced induction applications where belt driven pumps are normally used.
• Unlike other pumps, the VR Series arebuilt for continuous duty if needed.
• Billet aluminium construction for durability and good looks
• VR1 pump features a 10 AN O-ring inlet and outlet
• High flow and high pressure with low amperage draw
• Can be fully submerged in the fuel cell or chassis mounted
• Maximum amp draw of the VR1 is 19 AMPS and38 AMPS for the VR2
• Holley also offersa complete line of fuel filters and fuel pressure regulators that are designed to work as a system with thesepumps