Subli Vista Premium DIY Satin Pass Through Sublimation Spray is specifically designed to allow a sublimation image to pass through the spray layer on a non sublimation ready surface such as glass or acrylics, so when viewed from the front the image is see in all its glory with the pass through white layer behind the image for extra vibrancy.

To get the pass through effect you will need to apply a layer of Hi-Gloss Spray to the glass or acrylic first, then apply a layer of Pass Though Spray on top of that, and cure as directed.

How to Apply

Shake for 30 seconds to activate the product. Apply Hi-Gloss spray onto the substrate spraying at 20cm spraying left to right and from top to bottom, turn 90 degrees and spray again. Leave for 5 minutes then apply a top layer of Pass Through coating as above.

How to Cure

After spraying leave for up to 10 minutes then cure in an oven at 160C or 320F for 20 minutes depending on the thermal properties of the substrate. The product should be allowed to cool before pressing an image onto it.

Clean the Nozzle

After spraying turn the can upside down and depress the nozzle for 3 seconds to clean the nozzle for next use. This step is not required but will prolong the life of your aerosol nozzle.

Supporting Documents Download

Subli Vista Satin Pass Through Safety Data Sheet (SDS) - Aerosol

UV Blocking Systems Explainer for Application & Effectiveness

Subli Vista Product Brochure

Quick Reference Product Application Guide

Customer Support Application and Curing FAQs

Aerosol Safety Document