Keep your anchoring system running smoothly in harsh marine conditions with the Lewmar Pro-Series Generation 3 Gasket Kit. Designed as a direct replacement for the seals on Pro-Series Gen 3 windlasses, this kit tackles the common wear from saltwater exposure, UV rays, and constant mechanical stress. Boat owners know that a compromised gasket can lead to leaks, corrosion, or even gearbox failures—issues that sideline your vessel when you need it most.

Engineered for Long-Lasting Performance

Crafted from high-grade, marine-specific elastomers, these gaskets resist degradation better than generic alternatives. They maintain a tight seal around the windlass deck flange, preventing water ingress that accelerates wear on internal components. Unlike stock parts that might harden and crack after a season, this kit restores factory-level protection, ensuring reliable operation season after season.

• Durable materials formulated for saltwater and UV resistance
• Precision-molded for perfect fit on Gen 3 models
• Comprehensive set including all necessary O-rings and seals
• Easy to source and install during routine maintenance

Perfect Fit for Pro-Series Generation 3 Windlasses

This gasket kit is tailored exclusively for Lewmar's Pro-Series Generation 3 windlasses, covering models with the advanced Gen 3 design. It slots right into place without modifications, saving you time and frustration during refits. Whether you're prepping for offshore passages or just keeping your dayboat ready, these seals ensure your windlass deploys anchor chain flawlessly every time.

Boost Reliability and Extend Windlass Life

Regular gasket replacement is a smart preventive measure in boating. Fresh seals eliminate moisture buildup inside the housing, protecting gears and motors from rust and seizing. Boaters who've swapped in this kit report fewer breakdowns and smoother gypsy engagement, especially after winter layups. It's a small investment that pays off in peace of mind on the water.

Step-by-Step Installation Guide

Replacing the gaskets is straightforward for any DIY boater with basic tools. Here's how to do it right:

1. Power down the windlass and disconnect the battery to avoid accidental activation.
2. Remove the windlass from the deck if needed, or access the underside seals.
3. Clean mating surfaces thoroughly with a marine-safe degreaser to remove old gasket residue.
4. Inspect for wear on the windlass body and apply a thin layer of marine grease to new gaskets.
5. Position seals precisely per the Gen 3 layout, then reassemble and torque to spec.
6. Test operation in shallow water before full deployment.

Pro tip: Always check the rope/chain gypsy and motor brushes during this service for complete upkeep.

Essential Maintenance Tips for Windlass Owners

To maximize the lifespan of your Pro-Series Gen 3 setup:

• Inspect gaskets annually or after heavy use in rough seas.
• Rinse the windlass with fresh water after every outing to flush salt.
• Lubricate moving parts with waterproof grease during haul-outs.
• Avoid overloading—stick to rated line sizes for your model.
• Store in a dry berth during off-seasons to prevent gasket dry-rot.

These habits, paired with timely gasket refreshes, keep your anchoring gear battle-ready.

FAQ