PRODUCT DETAILS

TRIO Starlink GEN 3 Standard Speedmount and Rubber Coated Magnets Pack

One of the most highly reviewed and tested Starlink mount for vehicles and boats has arrived in Australia!

Designed for the GEN3 Standard & Enterprise dishes.

The TRIO Starlink GEN 3 Standard Speedmount and Rubber Coated Magnets Pack is a low-profile rugged solution for securely and conveniently mounting your Gen3 Starlink Standard dish on your van, motorhome, caravan, boat, car, tractor, or ute. At only 47mm in height (48.5mm with magnets), it provides edge protection for the dish. Installation is simple: slide the four pieces around the standard Gen 3 Starlink dish and tighten the four stainless steel screws into the SS nylon locknuts.

It also comes with Rubber Coated Magnetic Feet to permanently or temporarily attach to a magnetic surface. The set of 4 rubber coated magnets with female threads allow for M6 screws (for gen 3 mounts) to easily tighten in place. Stainless steel hardware included.

• Magnet dimensions: 600mm Diameter x 8mm High

• Holding Force: 27kg (each)

You can flat mount your Gen 3 dish permanently or temporarily on any vehicle, including vans, RVs, 4WD roof platforms, campers, boats, and sailboats. Multiple mounting options are available, including through-bolt in the corners, rubber-coated magnets, or suction cups, with VHB powder-coated steel discs for non-magnetic surfaces.

Manufactured in Canada, TRIO mounts are 3D printed from the same high quality UV resistant thermoplastic (ASA) that is used in automotive manufacturing (such as bumpers, wheel arches, mirror housings, etc.) and can be exposed to the elements without any concern of warping, deterioration or discoloration.

Assembled Dimensions

• Length: 624.5 mm
• Width: 403 mm
• Height: 47mm
• Weight: 1.8kg

Colour Options

• Black or White

Supported Dishes
Gen3 V4 Standard
Enterprise

Mounting Options
This TRIO Starlink mount does not come with other fixing accessories. We offer a range of mounting fixtures using the mount's four fixing points to suit your application:

• Through-bolt - to permanently screw into to a solid surface or rack accessory
• VHB Adhesive Landing Pads - adhesive pads to permanently bond to a solid surface 
• VHB Adhesive Backed Magnet Mounting Discs + Magnetic Feet - to temporarily attach to a surface that is not magnetic
• Suction Cups - to permanently or temporarily attach to an even and no-porous surface

** Starlinks factory kickstand or pole mount can still be used with the Speedmount.

** Combine it with our All-In-One 12/24V Starlink Power Supplies!

** Designed and tested for high speeds, but ensure the antenna mount is secured appropriately. Using Starlink™ in motion may violate your Terms of Service depending on your service location. Consult your Terms of Service to determine if this applies to you. Given the varying conditions of surfaces this can be mounted to, it is ultimately up to the end user to make sure the antenna mount is sufficiently secured. By purchasing and using this product, you agree to waive any claims that you may have against Powertec, and included entities, from any and all liability for any loss, damage, expense or injury, including death, that may suffer as a result of the use of the product, due to any cause whatsoever.