Enhanced Adhesion Strength — Activates EPDM surfaces to maximise bond performance with pressure-sensitive tapes and membranes

Rapid Drying Formula — Touch-dry in minutes, enabling efficient workflow and faster project completion

Optimised for Cured EPDM — Specifically designed to improve bond strength on fully cured rubber membranes

Versatile Detailing Solution — Ideal for edge trims, joints, seams, corners, and complex roof penetrations

Professional-Grade Reliability — Trusted for both domestic and commercial flat roofing installations

Long-Term Performance — Reduces risk of bond degradation, edge lift, and premature seal failure

Flashing Tape Preparation — Prime EPDM membranes before applying self-adhesive flashing tapes for superior bond integrity

Perimeter Detailing — Seal roof edges, fascia upstands, and perimeter details with confidence

Penetration Waterproofing — Detail around pipes, vents, skylights, and other roof penetrations

Corner Sealing — Ensure watertight seals at internal and external corners

Seam Reinforcement — Prepare seam areas for secure tape bonding and long-term durability

Upstand & Parapet Detailing — Create reliable waterproof transitions at vertical surfaces

Surface Preparation — Ensure the EPDM membrane is fully cured, clean, dry, and free from dust, dirt, oils, or other contaminants. Remove any loose debris and allow wet surfaces to dry completely before proceeding.

Application Method — Apply the primer evenly to the prepared EPDM surface using a clean applicator pad, lint-free cloth, or suitable brush. Work in manageable sections to maintain control and ensure consistent coverage.

Drying Time — Allow the primer to become touch-dry before applying self-adhesive tapes or detail membranes. Drying time will vary depending on ambient temperature, humidity, and ventilation. Do not apply tapes to wet or tacky primer.

Tape Installation — Once the primer is touch-dry, apply the self-adhesive flashing tape or detail membrane with firm, even pressure to ensure full contact and optimal bond development. Use a roller or hand pressure to eliminate air pockets.

Environmental Conditions — For best results, apply in dry conditions with ambient temperatures between 5°C and 30°C. Avoid application in wet, freezing, or excessively hot conditions.

Important Installation Notes

Always ensure adequate ventilation when working with primers and adhesives in enclosed or poorly ventilated spaces.

Test primer compatibility on a small, inconspicuous area before full application, particularly on aged or weathered membranes.

Do not apply primer to wet, frozen, or excessively hot surfaces. Optimal results are achieved in moderate, dry conditions.

Consult manufacturer guidelines for specific product compatibility and detailed safety information before use.