The LED Autolamps 37CARMB combo lamp throws amber and red light from a small 70 mm by 35 mm footprint, so it suits drawbars, guards and rear corners where space is tight. The lamp only sticks out about 30 mm, so it is less likely to catch when you back near posts or tight gateways. A 40 cm cable tail gives you enough length to reach a junction box on most box trailers or camper frames.

The housing runs a chrome bezel and tough polycarbonate lenses over solid-state LEDs, so there are no globes to rattle loose on corrugations after a few hundred kilometres. Three 6.0 mm mounting points on 40 mm centres lock the lamp down to steel or alloy without flex. Multi-volt circuitry covers standard 12 volt and 24 volt setups, which suits mixed utes and trucks in one towing fleet. ADR approval keeps the gear compliant for on-road use across Australia.

• LED Autolamps 37CARMB amber/red combination lamp
• Compact body measures 70 mm long by 35 mm high
• Low profile projection of approximately 30 mm from panel
• Three mounting holes on 40 mm centres for secure fit
• Mounting holes sized to take up to 6.0 mm hardware
• Pre-wired with 40 cm cable tail from the base
• Chrome bezel with ribbed polycarbonate amber and red lenses
• Multi-volt electronics suitable for 12V and 24V systems
• ADR approved for use on Australian road-registered trailers

Available in-store at Ashmores Caravan Services & Accessories
Pakenham, VIC