The updated CINEMA team favorite, FX2 freecoaster hub. Featuring proven KHE based internals, a 9t dual sealed bearing driver with additional bushing, and a super strong heat-treated chromoly 14mm axle with 6mm internal hex for easier maintenance. Updated with the DTC system, changing drive side only requires a driver change instead of a whole hub replacement. Slack can be adjusted from 55 degrees up to 180 degrees depending on your preference, and ships with 156 degrees slack as standard. The included nylon CR and DR hub guards keep your hub protected from grinds straight out of the box.

AXLE - 14mm Hollow Heat-Treated Chromoly
AXLE NUTS - 17mm Chromoly
SHELL - 6061-T6 Aluminum 36-hole
BEARINGS - 1 x 6002, 1 x 7905, 2 x 6902 + Bushing
DRIVER - 9-tooth
DRIVE SIDE - RHD or LHD
CLUTCH - DTC (Dual Threaded Clutch)
CONES - Threaded Drive Side and Non-Drive Side
GUARDS - Compatible with Cinema DR and CR hub guards
SLACK - Includes 3 Slack Washer For Fine Tuning
WEIGHT - 717g (w/ Guards Installed)

Dimensions:

• Drive side flange diameter - 58mm
• Non-Drive side flange diameter - 44mm
• Axle width (Locknut to Locknut) 110mm
• Drive side flange to locknut - 30mm
• Non-Drive side flange to locknut - 27mm

***Installation marked hub has been built and taken apart but never ridden.***