JET J-7020 10" × 16" Horizontal Metal Bandsaw

JET J-7020 for Accurate, Repeatable Metal Cutting

Six-Point Blade Guide System Stabilizes the Blade Through the Cut

The J-7020 uses adjustable blade guide assemblies with six cam follower bearings mounted on eccentric shafts on both sides of the blade. This contact arrangement keeps the blade from deflecting as it moves through stock. The result is a cut that tracks straight without drift, even in denser material cross-sections.

Cast Iron Blade Wheels Sustain Blade Momentum

Cast iron wheels carry more rotational mass than fabricated steel alternatives. That mass keeps blade speed steady as the saw enters a cut, reducing the chance of stalling or chatter. The 14-inch wheel diameter gives the blade a smooth tracking radius suited to the saw's cutting range.

Oil-Bath Transmission Delivers Consistent Drive Power

The heavy-duty transmission uses hardened and ground gears running in a sealed oil bath. This design reduces wear and keeps the drive train operating quietly under load. Variable blade speed from 100 to 350 SFPM lets you match the cut rate to the material rather than forcing the material to match a fixed speed.

Patented 3-Jaw Vise Speeds Workpiece Setup

The rapid-action moveable jaw on the 3-jaw vise reduces the time needed to clamp each piece. The vise swivels to 45 degrees so you can set up angle cuts without repositioning the stock by hand. An adjustable material stop gives you a repeatable reference point for production runs where every piece needs to land at the same length.

What's Included

What's Included? JET J-7020 10" × 16" Horizontal Metal Bandsaw

• JET J-7020 Horizontal Metal Bandsaw — The main saw unit with cast iron wheels, oil-bath transmission, six-point blade guides, 3-jaw vise, and swing-away control panel, ready for floor installation.
• Operator's Manual — Setup, operating, and maintenance instructions for the J-7020.

Specs

JET J-7020 10" × 16" Horizontal Metal Bandsaw Specifications

• Stock Number: JT9-414472
• Model Number: J-7020
• Motor: 1-1/2 HP, 115/230V, 1Ph
• Drive: Variable Speed
• Blade Speeds: 100–350 SFPM
• Blade Wheel Diameter: 14 in.
• Cutting Capacity — Rectangle at 90°: 10 x 10 in. and 7 x 16 in.
• Cutting Capacity — Rectangle at 45°: 6-1/2 x 11 in.
• Cutting Capacity — Round at 90°: 10 in.
• Cutting Capacity — Round at 45°: 10 in.
• Vise Swivel: 45°
• Overall Dimensions (L x W x H): 75-1/2 x 33 x 41 in.
• Net Weight: 973 lb.
• Gross Weight: 1,000 lb.
• Warranty: 2 Year
• Manual: Included — JET J-7020 Operator's Manual
  
  Warning: Cancer and Reproductive Harm. For more information, go to www.P65Warnings.ca.gov/product